Kennedale Electricians Who Treat Your Home Like a Neighbor's
We handle electrical repair, panel upgrades, lighting installation and EV charger installation for homes in Kennedale and nearby towns like Arlington and Mansfield. We find the cause, explain it in plain words and agree on a written price before any wiring starts. Then we do the work carefully and leave your home clean.
- Written price before work
- Permits handled as required
- Plain answers, no pressure
- Cleanup before we leave
Towns We Cover
Our home base is Kennedale, TX, and we work in houses throughout the nearby area, including Rendon, Forest Hill, Everman, Arlington, Mansfield, Crowley, Edgecliff Village, Grand Prairie, Burleson and Haltom City.
- Kennedale
- Rendon
- Forest Hill
- Everman
- Arlington
- Mansfield
- Crowley
- Edgecliff Village
- Grand Prairie
- Burleson
- Haltom City
Don't see your town? Ask us on the phone, and we'll give you a straight answer about whether we can reach you.
Electrical Work for Your Home, Inside and Out
Most calls are everyday work: electrical repair for dead outlets and tripping breakers, lighting installation, and panel upgrades when the old panel can't keep up. We also do EV charger installation in garages and driveways, plus whole-home rewiring, remodel and addition wiring, and code corrections when an inspection turns something up. For backup power we install standby generators, handle generator service and repair, and set up home battery backup systems. Surge protection and torque and cleans round it out, keeping the connections in your panel tight and your electronics protected.
Panel Upgrades
We replace worn, crowded or undersized electrical panels with one sized for your home's actual load, and we handle the permit, inspection and utility coordination.
Electrical Repair
Tripping breakers, dead outlets, flickering lights and warm switch plates traced to the real fault and repaired with a clear price first.
Lighting Installation
Recessed lights, new fixtures, ceiling fans, dimmers and outdoor lighting, wired on supports rated for the load and finished with a clean patch.
EV Charger Installation
Level 2 home chargers on a dedicated 240-volt circuit, with a panel load check first and the permit handled for you.
Whole-Home Rewiring
Replace worn, ungrounded or aluminum wiring with new circuits, done in stages so you can keep living in your home while we work.
Generator Installation
Standby generators and portable generator hookups, sized to the circuits you rely on and connected safely through a transfer switch.
Generator Service & Repair
Routine upkeep, testing and repair for standby generators and transfer switches, so your backup power works on the day you need it.
Home Battery Backup
Quiet stored power that keeps your fridge, lights, internet and medical devices running when the grid drops, planned around your panel and your habits.
Remodel & Addition Wiring
New circuits, outlets and lighting for kitchens, baths and additions, planned before the walls close and wired to pass inspection the first time.
Code Corrections & Inspection Fixes
We work through the electrical items on an inspection report or correction notice and fix each one to code, with no extra work added to the list.
Surge Protection
A surge protective device at your main panel, plus a check of your grounding, so spikes from storms and the grid have a safe path out of your home.
Torque & Cleans
We power down your panel, clean out dust and debris, and tighten every lug and breaker screw to the maker's spec so connections stay cool.
Electrical Work From People Who Pick Up the Phone
Electrician Kennedale is a small local company that does residential electrical work in Kennedale and the towns around it. The idea is simple: treat every house like it belongs to a neighbor, because around here it often does.
That shows up in small ways. We return calls, show up when we say we will and explain what we're doing without talking down to you. If a cheaper repair will do the job safely, we'll tell you, even when a bigger job is on the table.
We'd rather earn the next call than oversell this one. Most of our work comes from people who want an electrician they can call again in five years and get the same straight answer.
- License
- Master Electrical License; Licensed electrical contractor, TECL 36609
- Warranty
- 1-year workmanship warranty
How We Handle Your Job
Each job gets the treatment we'd expect in our own home: a plain explanation, a price you approve first, and rooms left the way we found them.
- Master Electrician Licensed
- A Master Electrical License backs our work, and the company is a licensed electrical contractor, TECL 36609. You always know who answers for the job, from the first visit to the last.
- Workmanship Covered for a Year
- All our work carries a 1-year workmanship warranty. If anything we installed or repaired stops working right in that time, give us a call and we'll come take a look.
- We Find the Cause First
- Testing comes before replacing. If a breaker keeps tripping, we track it down to the circuit, device or connection that is really at fault. We show you what we found, often in photos, and give you a straight answer on whether a repair will last or a replacement is the better choice.
- A Bill With No Surprises
- Before we start, you get a written, itemized scope. If opening a wall reveals something no one could have known about, we pause, show you and talk it over before continuing.
- Your Home Treated With Care
- Drop cloths go down, shoe covers go on indoors and access holes get patched neatly. Before leaving, we clean up, test each circuit we worked on and label the panel so it makes sense to you.
How a Job Runs, Start to Finish
Most jobs follow the same few steps, so you always know what happens next.
- 1
Tell Us What's Going On
Call and describe the problem or project. We'll ask a few questions and book a service visit at a time that suits your schedule.
- 2
Service Visit and Testing
We look at the panel, test the circuits involved and find the cause. You'll hear what we found in plain language.
- 3
Written Scope and Price
We write up the work, the options and the cost. You decide, with no pressure to say yes on the spot.
- 4
The Work, Permit Included
We pull the permit where one is required, protect your floors and keep the power off only as long as the work needs. If an inspection is part of the job, we schedule it and meet the inspector.
- 5
Walkthrough and Cleanup
We test everything, show you what changed and answer your questions. The work area is cleaned up before we head out.
What Shapes the Price of Electrical Work
Two jobs with the same name can cost very different amounts. One panel upgrade is a straightforward swap, while the next also needs a new meter base and service wire. We price after we've seen the job, and we tell you which of these factors is moving your number.
After the service visit you get a written estimate broken into line items, so you can see what each part of the job costs. Nothing is added without your OK.
- Size of the Job
- The number of circuits, fixtures or rooms involved sets the base. Adding one outlet is a short visit, while rewiring a whole house takes days of careful work.
- What's Already in the Walls
- Older wiring, ungrounded circuits, aluminum branch wiring or past do-it-yourself work can all mean extra corrections. We point these out during the visit so they show up in the estimate, not halfway through the job.
- Access
- Open attics and unfinished garages are quick to work in. Finished walls, tight crawl spaces and long runs across a slab foundation take more time, and attic work in a Texas summer has to be scheduled for the cooler hours of the day.
- Equipment You Choose
- Fixture style, charger model, generator size and battery capacity all change the cost. We'll lay out a couple of options at different levels so you can choose what fits.
- Permits and Inspections
- Many jobs need a permit and an inspection, handled as required by your local jurisdiction. Those fees and inspection visits are part of the estimate, not an add-on later.
- Utility Coordination
- Service upgrades and some generator work need the power company to disconnect and reconnect your service. Scheduling around that can affect timing and cost.
Questions Homeowners Ask Us Most
- Do you handle the permit for my job?
- Yes. When a job needs a permit, we apply for it and schedule the inspection as your local jurisdiction requires. Permits come up most for panel upgrades, new circuits, EV chargers, generators and rewiring. The fee appears as a separate line on your written estimate, so you see it from the start.
- What makes a breaker keep tripping?
- Usually it's one of three things: the circuit is being asked to carry more than it was designed for, a wire or device has a fault sending current the wrong way, or the breaker has worn out with age. Space heaters, window units and kitchen appliances sharing a circuit are common culprits. We test to find out which it is, then tell you whether a repair, a dedicated circuit or a new breaker is the fix. If a breaker trips again right after you reset it, leave it off until we've checked it.
- How much time does a panel upgrade need?
- Expect the swap to fill most of a day, with the power off through much of it. When the power company has to be involved or a new meter base is needed, the timing follows their schedule. Your estimate includes the expected timeline so you can plan ahead.
- Can you put an EV charger in my garage?
- Usually, yes. We look at how much capacity your panel has, how far it is from where you park and which charger you want, then run a dedicated circuit to it. If the panel is close to its limit, we go over the choices, such as load management or a panel upgrade, before you decide.
- Will you need to shut off my power?
- Just on the circuits we're working on, and just for as long as the work takes. With small jobs like an outlet or a new fixture, the rest of the house usually keeps power. Larger jobs like a panel upgrade turn off the whole house for part of the day, and we let you know in advance so you can plan meals, calls and the thermostat.
- Is your work covered by a warranty?
- Yes, a 1-year workmanship warranty. If anything we installed or repaired isn't right during that year, tell us and we'll return to check it. Equipment like chargers and generators carries its own manufacturer coverage, which we explain when we do the job.
- Can you set up generators and battery backup?
- We can. Our work includes generator installation, generator service and repair, and home battery backup systems. We go over which circuits you want running in an outage and size the system to fit, so you don't pay for capacity you won't use.
Let's Find Out What Your Home Needs
Describe what's happening and we'll pick a time to stop by. You'll hear plainly what's wrong and get a written price before any work starts.